Fujitsu ETERNUS DX100 S3 Setup Manual

Also see for ETERNUS DX100 S3: Configuration guide Safety precautions Configuration guide Configuration guide User guide

Contents

Chapter 4 Configuration Settings for RAID Groups or Thin Provisioning4.2 When Using Standard VolumesFUJITSU Storage ETERNUS DX Configuration Guide (Web GUI)Copyright 2014 FUJITSU LIMITED P2X0-1250-06ENZ0524.2 When Using Standard VolumesThe following section describes the series of settings when creating Standard volumes.Not only can new RAID groups be created, adding or changing volumes that are registered in existing RAIDgroups can be performed.Standard volumes are also used as copy destination volumes for OPC, EC, or REC.Create RAID GroupCreate a RAID group (a group of drives that configures the RAID in the ETERNUS DX).Refer to:- "RAID Group Creation" in "FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage systemConfiguration Guide (Basic)"- "RAID Group Creation" in "FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage systemConfiguration Guide (Basic)"- "RAID Group Creation" in "FUJITSU Storage ETERNUS DX200F All Flash Array ConfigurationGuide (Basic)"Create VolumeCreate a volume (drive area in the RAID group). A volume is a structural unit of RAID that can berecognized from the server. Select "Standard" for "Type".Refer to:- "Operation Volume Creation" in "FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storagesystem Configuration Guide (Basic)"- "Operation Volume Creation" in "FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storagesystem Configuration Guide (Basic)"- "Operation Volume Creation" in "FUJITSU Storage ETERNUS DX200F All Flash Array Configura-tion Guide (Basic)"