Fujitsu AIRSTAGE J-IIIL Design & Technical Manual

• Pattern B1. Use a tool to cut off the terminal on the end of the remote controller cable, and then removethe insulation from the cut end of the cable as shown below.Remotecontroller cable(Non-polar)13/16 in (20 mm)2. Connect the remote controller cable and connecting cable as shown below. Be sure to insu-late the connection between the cables.Remotecontroller cable(Non-polar)InsulatedconnectionWhiteBlackRedConnectingcableCut andinsulate3. Connect the remote controller cable to the connecting cable, and insert it to the connector.Set the DIP switch (SW1) to “2WIRE” on the PCB of the indoor unit.Indoor unitPCBRemote controllercable (Non-polar) Connecting cable Connector CNC01(onboard)Connect to earth(ground) screw Functional earthing(If necessary)Set the DIP switch(SW1) to “2WIRE”NOTE: Layout of terminal block and PCB is varies depending on the type of indoor unit.Connector(adapter)SW1Indoor unitPCB¢ SpecificationsDimensions (H × W × D) in (mm) 4-3/4 × 2-15/16 × 3/4 (120 × 75 × 19)Weight oz (g) 4 (120) Wiring specificationsUse Cable size Cable type RemarksRemote controllercable22 to 16 AWG(0.33 to 1.25 mm2)Sheathed cable Non polar 2-core, Twisted pairShielded cable**: Use shielded cable in accordance with local rules for remote controller cable.2-10. Simple remote controller (Without operation mode: UTY-RHRY) - (05-81) - 2. Control unitsCONTROLSYSTEMCONTROLSYSTEM