Fujitsu 1FINITY L100 User Manual

5.6.1Configure LCN1 with Static IP AddressPrerequisite:■ If port LCN1 requires a pluggable SFP module, the SFP is installed and its autoprovisioning is complete.OverviewAt the site where the NE is installed, the Local Area Network (LAN) connects to a router and the DCN is reachablethrough the router. This section describes the procedure to configure a static IP address on LCN1, configure thedefault next-hop IP address, and install a LAN cable connecting LCN1 to the LAN. The LAN cable can connectdirectly to a LAN switch port as shown in the following figure.Virtuora UserInterfaceWebGUICLINETCONF/YANGRouterNext-hop IP addressVirtuora NCDCN SwitchLANRemote Users NE Installation Site1FINITY NELCN1LAN cableFigure 87LAN Switch Port ConnectionThe following figure shows how to save LAN switch ports by connecting the LAN cable to a daisy chain of LANcable connections between 1FINITY NEs.Virtuora UserInterfaceWebGUICLINETCONF/YANGRouterNext-hop IP addressVirtuora NCDCN SwitchLANNE ManagementMode = Bridge1FINITY NE1FINITY NE1FINITY NELCN1LCN2LCN2LCN1LCN1LAN cableRemote Users NE Installation SiteFigure 88Daisy Chain LAN ConnectionInitial System Turn UpConfigure IP Connection to DCN170Release 19.1.1 · Issue 1.1, May 2021 Fujitsu and Fujitsu Customer Use Only