Fab Fours M2250 Installation Instructions Manual

Fab Fours M2250 Installation Instructions Manual Manual pdf 1 page image

Installation InstructionsLicense plate bracketProduct Number: M2250, M2251, M2350For application with the Vengeance bumper lineSAFETYYour safety and the safety of others is very important. In order to help you make informed decisions about safety, we have provided installationinstructions and other information. These instructions alert you to potential hazards that could hurt you or others. Please do a job safety analysis (JSA) before each task to identify potential hazards foryour situation and remove/protect against them. You must use your own good judgment, and take your time.Read and understand all safety precautions and instructions before installing this product.THIS PRODUCT IS FOR OFFROAD USE ONLY. ALL LIABILITY FOR INSTALLATIONAND USE RESTS WITH THE OWNER.CARELESS INSTALLATION AND OPERATION CAN RESULT IN SERIOUS INJURYOR EQUIPMENT DAMAGE.Injury hazardFailure to observe these instructions could lead to severe injury or death. Always remove jewelry and wear eye protection. Always use extreme caution when jacking up a vehicle for work. Set emergencybrake and use tire blocks. Locate and use the vehicle manufacturers designatedlifting points. Use jack stands. Always use appropriate and adequate care in lifting components into place. Always insure components will remain secure during installation and operation. Always wear safety glasses when installing this kit. A drilling operation willcause flying metal chips. Flying chips can cause serious eye injury. Always use extreme caution when drilling on a vehicle. Thoroughly inspect thearea to be drilled (on both sides of material) prior to drilling, and relocate anyobjects that may be damaged. Always use extreme caution when cutting and trimming during fitting. Always tighten all nuts and bolts securely per installation instructions. Always route electrical cables carefully. Avoid moving parts, components thatbecome hot and rough or sharp edges. Always insulate and protect all exposed wiring and electrical terminals. Always perform regular inspections and maintenance on mounts andrelated hardware.

/ 3

Related manuals for Fab Fours M2250