Fab Fours H3450 Installation Instructions Manual

Fab Fours H3450 Installation Instructions Manual Manual pdf 1 page image

Installation InstructionsGMC Canyon Premium Front BumperProduct Number: H3450, H3451, H3452Application: 2015-2018 GMC CANYONCopyright 2008 Fab Fours, Inc. Page 1 of 15 H345X_REV_ASAFETYYour safety and the safety of others is very important.▪ In order to help you make informed decisions about safety, we have providedinstallation instructions and other information.▪ These instructions alert you to potential hazards that could hurt you or others.▪ Please do a job safety analysis before each task to identify potential hazards for yoursituation and remove/protect against them.▪ You must use your own good judgment, and take your time.Read and understand all safety precautions and instructions before installing this product.THIS PRODUCT IS FOR OFFROAD USE ONLY. ALL LIABILITY FORINSTALLATION AND USE RESTS WITH THE OWNER.CARELESS INSTALLATION AND OPERATION CAN RESULT IN SERIOUS INJURYOR EQUIPMENT DAMAGE.Injury hazardFailure to observe these instructions could lead to severe injury or death.❑❑ Always remove jewelry and wear eye protection.❑❑ Always use extreme caution when jacking up a vehicle for work. Setemergency brake and use tire blocks. Locate and use the vehiclemanufacturers designated lifting points. Use jack stands.❑❑ Always use appropriate and adequate care in lifting components into place.❑❑ Always ensure components will remain secure during installation andoperation.❑❑ Always wear safety glasses when installing this kit. A drilling operation willcause flying metal chips. Flying chips can cause serious eye injury.❑❑ Always use extreme caution when drilling on a vehicle. Thoroughly inspectthe area to be drilled (on both sides of material) prior to drilling, andrelocate any objects that may be damaged.❑❑ Always use extreme caution when cutting and trimming during fitting.❑❑ Always tighten all nuts and bolts securely per installation instructions.❑❑ Always route electrical cables carefully. Avoid moving parts, componentsthat become hot and rough or sharp edges.❑❑ Always insulate and protect all exposed wiring and electrical terminals.❑❑ Always perform regular inspections and maintenance on mounts andrelated hardware.