FBI XL-1T Installation And Setup Manual

FBI XL-1T Installation And Setup Manual Manual pdf 33 page image

6–1S E C T I O N 6Installer Modes• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •Entering Installer ModeTO ENTER INSTALLER MODE, PRESS [CODE][Q][INSTALLER][X]Where:[CODE] CODE button[Q] [Q] key[INSTALLER] 4-digit Installer Code (default = 2468)[X] Single digit indicating the installer mode as follows:[1] INSTALLER KEYPAD PROGRAMMINGPress 1 and 3 (at the same time) SYSTEM DEFAULTPress 7 and 9 (at the same time) USER CODE DEFAULTInstaller Mode 1 (Installer Keypad Programming)Selecting this option enters the installer into keypad programming mode. Refer to KeypadProgramming in Section 7: System Programming.An option exists in the EZ-Mate downloader software to inhibit keypad programming. If selected,any attempt to enter this mode will prompt a negative acknowledgment of four short beeps. Thesoftware has another option (Default Lockout) to inhibit a second installer from defaulting the paneland entering keypad programming. The feature prevents unauthorized installers from accessingthe control.Installer Mode 1 (System Default)Any of the system keypads (LED and LCD) can initiate a system default by pressing the 1and 3 keys at the same time while in the Programming mode. The system will default tothe factory-programmed values, perform the reset sequence, and perform the warm-up timesequence. A system default can be generated by removing power (AC and DC), shorting JP1and JP2, reapplying power (with JP1 and JP2 still intact), waiting eight seconds, andremoving the short while still applying power.A programming option, called Default Lockout, can be selected through the EZ-Mate downloadersoftware. If selected, a system default reset will change all of the programmable options, with theexception of the CSID (a code used by the software to identify the panel during remoteconnections) and the Installer Code. This prevents unauthorized installers from accessing thecontrol.Installer Mode 1 (User Code Default)The User Codes can be reset to factory default values (User Code 1 = 1234) by pressing the 7and 9 keys at the same time, while in the Programming mode. The User Codes will bereset to the factory default codes; the system will perform the reset sequence and the warm-up time sequence.Installer Mode 2 (System Log View)The system retains the past two alarm memory conditions. The system can store from 1-6alarms per arming cycle, or up to 12 alarms for two arming cycles. LED keypads will display