FBI XL-1T Installation And Setup Manual

FBI XL-1T Installation And Setup Manual Manual pdf 12 page image

XL-1T Installation and Setup Guide2–2The front face of the enclosure can be completely removed to gain unrestricted access to thecontrol panel during installation.• Open the enclosure to its fully extended position (approx. 90 degrees)• Lift the control panel door and remove the door from the enclosure.Mounting the XK-104 KeypadThe XK-104 Keypad may be surface-mounted in the following ways:A. Directly to a control panel having a keypad cutout on the front of its enclosure.B. Directly to a single- or double-gang electrical junction box.C. Directly to a wall or other surface.Procedure for Mounting the XK-104 Keypad:1. Remove the keypad cover assembly from the rearmounting plate. Insert a small screwdriver blade in theCover Pry-Off Slots at the lower edge of the keypad (seeDiagram 1) and twist to pry off the cover assembly.2. Mount the rear plate (see Diagram 2).NOTE: The plate is correctly oriented when its partnumber, molded into the plastic, is upright.A. Mounting Directly to Control Panel Enclosure:If the control panel has a keypad cutout on the frontface of its enclosure, remove the cutout and mount theplate to the enclosure's face via holes "A" (seeDiagram 2) and the four screws and nuts provided.B. Mounting Directly to an Electrical JunctionBox:The plate can be mounted directly to a single- ordouble-gang electrical junction box. Use the screwholes provided and holes "B" for a single gang-box; orholes "A" for a double-gang box.C. Mounting Directly to a Wall or Other Surface:Make a wiring hole in the mounting surface. Positionthe plate's wiring opening over the mounting surfacehole. Mount the plate, using holes "A" and/or "B" inconjunction with appropriate mounting hardware (notprovided) for the type of surface.3. Complete the keypad wiring as required for the controlwith which the keypad is to be used.4. Replace the keypad cover assembly on the rear plate.Starting at the upper edge of the plate, engage the twoholding hooks (see diagram 3) into the recesses providedfor them inside the upper edge of the cover assembly, andsnap the lower edge of the cover assembly onto the twosnap hooks at the lower edge of the plate.Figure 2-2: Mounting the XK-104 KeypadIf desired, cover and plate can be further secured together by inserting a screw (provided) into theslot at the keypad's lower edge.COVER DOORBREAK-AWAY RIBS (4)(FOR EXPOSED WIRING ENTRY.)SLOT FOR COVER SECURING SCREW(OPTIONAL)COVER PRY-OFF SLOTS (2)(TO REMOVE COVER, INSERT SMALLSCREWDRIVER BLADE AND TWIST.)REAR PLATEDiagram 1: BOTTOM VIEW OF KEYPADBREAK-AWAY RIBS (4)(FOR EXPOSED WIRING ENTRY.)WIRING OPENING(FOR CONCEALEDWIRING ENTRY.)A B AA B AN6054POST FOR COVERSECURING SCREW (OPTIONAL)SNAP HOOKS (2)(FOR HOLDING COVER'SLOWER EDGE)HOLES "A" OR "B"(CAN BE USED FORWALL MOUNTING)HOLES "A" (4)(FOR MOUNTING TOCONTROL PANEL'SENCLOSURE ORTWO GANGELECTRICAL BOX)HOLES "B" (2)(FOR MOUNTING TOSINGLE GANGELECTRICAL BOX)HOLDING HOOKS(FOR HOLDING COVERS UPPER EDGE)Diagram 2: REAR MOUNTING PLATE