138Chapter 12Troubleshooting12-5 Certification informationJapan* Except for model SS-300 Model: SS-300/SS-500/SS-700USAFCC ID: BKMAP001 *Except for model SS-300WristableGPSModel: SS-300/SS-500/SS-700FCC NOTICEThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) Thisdevice may not cause harmful interference, and (2) this device must accept any interference received, includinginterference that may cause undesired operation.Caution: Changes or modifications not expressly approved by the party responsible for compliance could void theuser's authority to operate this equipment.Properly shielded and grounded cables and connectors must be used for connection to host computers and / orperipherals in order to meet FCC emission limits.Use a genuine USB cable with a ferrite core.This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in aresidential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installedand used in accordance with the instructions, may cause harmful interference to radio communications. However,there is no guarantee that interference will not occur in a particular installation. If this equipment does causeharmful interference to radio or television reception, which can be determined by turning the equipment off andon, the user is encouraged to try to correct the interference by one of the following measures:· Reorient or relocate the receiving antenna.· Increase the separation between the equipment and receiver.· Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.· Consult the dealer or an experienced radio/TV technician for help.This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.This equipment complies with FCC radiation exposure limits set forth for an uncontrolled equipment and meets theFCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65. This equipment has very low levels of RFenergy that are deemed to comply without testing of specific absorption ratio (SAR).All EPSON products with the ANT+ logo have been certified as interoperable by ANT+. For more information, visitwww.thisisant.com/directoryIn case you purchases further HR sensors, we recommend using optional EPSON products.