Epson Stylus Photo PX700FW Service Manual

Also see for Artisan 700 Series: User guide User guide Product support bulletin Basic guide Network installation guide

Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W Revision CADJUSTMENT Adjustment without Using Adjustment Programhttps://www.manualsbooks.com239ConfidentialChecking the result of PG adjustment1. Move the carriage to the center of the platen, and place one of the 1.1 mm thicknessgauges aligning the left edge with the third rib from the left end of the Front PaperGuide to the fifth rib. Then place the other 1.1 mm thickness gauge aligning the rightedge with the second rib from the right end of the Front Paper Guide to the fifth rib.( Fig. 5-41 )Figure 5-41. Setting the thickness gauge2. Pull the Timing Belt to move the carriage to both ends and confirm the carriagedoes not touch the gauges.3. If the carriage comes in contact with a gauge, perform the adjustment again.4. Move the carriage to the center of the platen, and place 1.3 mm thickness gaugeson the same position in step1 (instead of 1.15mm ones).5. Pull the Timing Belt to move the carriage to both ends and confirm the carriagecomes in contact with the gauges.6. If the carriage does not touch the gauges, perform the adjustment again.� � � �� Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/EpsonArtisan 700/Epson Stylus Photo PX700W/TX700W have five PGpre-settings using the APG mechanism. Use the minimum PGsetting (PG – : 1.2mm) to carry out this checking. See Figure. 5-36.Gauge (1.15 or 1.3mm) placementLeft sideGauge (1.15 or 1.3mm) placementRight side