Epson Stylus Photo PX700FW Service Manual

Also see for Artisan 700 Series: User guide User guide Product support bulletin Basic guide Network installation guide

Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W Revision CADJUSTMENT Adjustment Items and Overviewhttps://www.manualsbooks.com210Confidential5.1 Adjustment Items and OverviewThis chapter describes adjustments required after the disassembly/reassembly of theprinter.5.1.1 Servicing Adjustment Item ListThe adjustment items of this product are shown below.Table 5-1. Adjustment ItemsAdjustment Item Purpose Method Outline ToolAdjustment ItemsPG AdjustmentInstall the Head Nozzle surface parallel to the printing surface and set thegap between the paper and the Head Nozzle surface to the specified value.For the adjustment method, see 5.3.1 “ PG Adjustment (p235) ”.If the position of the notch on the Parallelism AdjustmentBusings have not changed, only “ Checking the result of PGadjustment (p239)” is necessary.• Parallelismadjustment jigs(two types; the onefor 0th column sideand the one for 80thcolumn side)• Fixtures forprecision control• Thickness Gauge1.15mm, 1.3mm• Phillips screwdriver• Hex wrenchCR timing belt tensionadjustmentThis adjustment is made to avoid the idling of the CR motor (fatal error) orbreaking of the motor coil or the like due to an abnormal heat.For the adjustment method, see 5.3.2 “ CR Timing Belt TensionAdjustment (p240) ” .• Tension gauge• Tweezers• (+) PhillipsscrewdriverPF timing belt tensionadjustmentThis adjustment is made to avoid the idling of the PF motor (fatal error),breaking of the motor coil due to an abnormal heat, or lost of paper feedaccuracy that causes banding on the printout.For the adjustment method, see 5.3.3 “ PF Timing Belt TensionAdjustment (p241) ” .• Tension gauge• Tweezers• (+) PhillipsscrewdriverTouch Panel Adjustment(Epson Artisan 800/EpsonStylus Photo PX800FW/TX800FW only)This adjustment is made to adjust the relative positions between the TouchPanel detection points and displaying positions on the Control Panel.For the adjustment method, see 5.3.4 “ Touch Panel Adjustment(Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FWonly) (p242) ” . ---� � � �� For information on how to carry out the adjustments andmedia required for the adjustments, see the instructionsdisplayed by the adjustment program.To avoid the auto head cleaning by the AID function whilecarrying out each adjustment, you can turn off the auto headcleaning by operating the LCD Panel as follows.1. Turn on the printer.2. Select “ Setup” - “ maintenance” - “ Automatic HeadMaintenance” from the menu displayed on the LCDPanel, and change the auto head cleaning setting to OFF.