Epson RC700 Manual

Also see for RC700: Manual Manual Manual Manual Original instructions

Contents

2. InstallationRC700 / RC90 Option Fieldbus I/O Rev.12 167Configure switch configurationThe PROFINET module requires no configurations.All the PROFINET communication configurations are set by the development software(EPSON RC+ 7.0).WiringPROFINET connector is RJ45 connector. Use 100BASE-TX (STP type) cable.CAUTION Be sure to use cables and connectors complying with the industrial standards ornoise resistant Ethernet cable (STP cable). If you use an office use product orUTP cable, it may cause communication errors and may not offer the properperformance.Module InstallationWARNING Make sure that the power is turned OFF before installing/removing any modulesor connecting/disconnecting any cables. Working with the power ON isextremely hazardous and may result in electrical shock and/or malfunction ofequipment.Install the module to the dedicated slot on the T3 series Manipulator.Reference manual:T3 series Manipulator Setup&Operation 17. Fieldbus I/O