Using DISKCOPY with one drive onlyIf your computer has only one diskette drive and no hard disk,follow these steps to copy a diskette:1. Make sure the diskette you want to copy is write-protected.(See Chapter 2 for instructions.)2. Insert the Operating 1 diskette in the diskette drive.3. At A> prompt, type the following and press Enter:DISKCOPY A: A:MS-DOS displays this message:Insert SOURCE diskette in drive A:Press any key when ready . . .4. Remove the Operating 1 diskette and insert the disketteyou want to copy (the source) in the diskette drive andpress any key. DISKCOPY copies the contents of thediskette to the computer’s memory. Then the screendisplays this message:Insert TARGET diskette in drive A:Press any key when ready . . .5. Remove the original diskette from drive A and insert theblank diskette (the target) in the drive. Press any key. Ifthe new diskette is not formatted, DISKCOPY formats itand then copies the contents of memory to the diskette.When the copy is complete, you see this message:Copy another diskette (Y/N)?6. Press Y and Enter to copy another diskette or N and Enterto return to the MS-DOS command prompt.3-32 Using MS-DOS With Your Computer
