7InstallationFloor Mount InstallationThe anti-tip bracket is to be located on thefloor in the left or right rear corner of thewine cooler.Step by step instructions for locatingthe position of the bracket:1 Decide where you want to place thewine cooler. Slide it into place, beingcareful not to damage the floor, leaving 1"(2.5cm) of clearance from the rear wall toallow room for the anti-tip bracket.2 Raise the rear leveling legsapproximately ¼" (6mm) to allowengagement with the anti-tip bracket.Level the unit by adjusting all the levelinglegs as required. Turning the leveling legcounterclockwise will raise the unit andclockwise will lower the unit.3 Make sure the wine cooler is in thedesired location, then mark on thefloor the rear and side corner of thecabinet where the anti-tip bracket willbe installed. If the installation does notNOTEIf installing on a concrete floor, concretefasteners are required, (not included withthe anti-tip kit).allow marking the rear corner of thecabinet, then make temporary lineson the floor marking the front cornerof the cabinet, excluding the drawer.Slide the wine cooler out of the way.From the temporary line extend thesidewall line back 21½" (54.6cm).4 Align the anti-tip bracket to the markson the floor so the side of the bracketlines up with the side of the cabinetmark, and the "V" notches on the anti-tip bracket line up with the end of the21½" (54.6cm) line (Rear of cabinet line).5 Fasten the anti-tip bracket to the floorusing the supplied screw.6 Slide the cabinet back into position,making sure the rear cabinet levelingleg slides under the anti-tip bracketengaging the slot.21 1/2"(54.6cm)"V" notchesin bracket"V" notchesin bracketSide of cabinet lineFront of cabinet lineRear ofcabinet lineRear Leveling legScrewWARNINGTIP OVER HAZARD: Oneof the rear cabinet levelinglegs must be engagedunder an anti-tip bracket.ALL UNITS CAN TIPAnti-TipBracket Leveling LegFront ofcabinet21 1⁄2"(54.6cm) Bottom View ofWine cooler