Electrolux EN19WI30LS Installation Manual

Also see for EN19WI30LS: Use and care manual Service manual User and care manual Dimensions and specifications Installation manual

Contents

29Remote ControllerInstall the remote controller according to the instructions in the Installation Guide (p. 36).* Only one remote controller can be connected to the water heater.A malfunction may occur if two or more remote controllers are connected.* The water heater has been factory set to allow a maximum temperature setting of [120 °F / 50 °C].To access higher temperature settings through the remote controller, follow the below steps. setting the maximum temperature to [125 -140 °F / 55 - 60 °C]>1. Turn the water heater off by pressing the Power On/Off Button on the remote controller.2. Press and hold the FLOW METER ALARM SET Button until a sound is heard (2 sec.) and [120 °F / 50 °C]appears on the display.3. Set the upper limit of the hot-water supply temperature to [125 °F, 130 °F, 135 °F or 140 °F / 55 °C or 60 °C]using the UP and DOWN setting Buttons.4. To put the water heater back into operation, press the Power On/Off Button on the remote controller.To keep the water heater off, let the unit sit for 30 sec. to return to the original display.• This unit can be programmed so that it will default to one of three temperatures if the remotecontroller is removed [140 °F (60 °C), 135 °F (57 °C), 120 °F (50 °C)]. To change the defaulttemperature, adjust the dip switches as described below. The default temperature is 120 °F (50 °C).1. Disconnect electrical power to the water heater.2. Remove the front cover of the water heater (4 screws).3. Disconnect the remote controller. Adjust the dip switches as illustrated below.4. Replace the front cover of the water heater (4 screws).5. Reconnect electrical power to the water heater.• When changing the temperature, make sure to confirm with the customer that the temperatureof the hot water will be very high and that there is a risk of scalding.• Hot water heater temperatures over 125 °F (52 °C) can cause severe burns instantly or deathfrom scalding.DANGER* Remarks [125 °F / 55 °C]Fahrenheit display modeCelsius display mode* Do not change any other dipswitches.* High temperature.1 2ON= OFF=120 F (50 C)135 F (57 C)140 F (60 C)CheckCheck