Electrolux EI15TC65HS Technical & Service Manual

Also see for E15TC75HPS - Fully Integrated Trash Compactor: Use and care guide Factory parts catalog Specifications

33Section D – Electrical ComponentsSCREWSRemove two Phillips head screws (in above illustration,4.shown in place from the top) from the bottom of theright stabilizer plate and remove the odor disk gearmotor.Reassemble unit in reverse order.5.Power CableREMOVE AND REPLACEIf the power cable becomes worn or frayed, replace it.GROMMETGROUNDSCREWRemove the back panel from the compactor (see1.Access to Components, Remove Cabinet Cover).Rotate the power cord grommet 90° and slide it out2.of the slot in the cabinet frame.Remove the screw securing the cord’s green ground3.wire to the frame.Cut the black and white power cord wires beyond the4.crimp connectors and remove the cord.Strip, connect and crimp the black and white wires5.of the replacement cord to the unit per the electricalschematic on the inside of the back panel (or in thismanual).Attach the cord’s green ground wire to the top frame,6.and secure with the original screw.The standard color coding for safety ground wiresis GREEN, or GREEN WITH YELLOW STRIPES.Ground leads are not to be used as current-carryingconductors. It is EXTREMELY important that theservice technician re-establish all safety groundsprior to completion of service. Failure to do so willcreate a hazard.Install the grommet on the cord and insert in cabinet7.frame.Re-install back panel.8.