WARNING!Be very careful when you useopen fire in the kitchenenvironment. Themanufacturer declines anyresponsibility in case of theflame misuse.1. Push the control knob down and turnit counterclockwise to the maximumgas supply position ( ).2. Keep the control knob pushed forequal or less than 10 seconds. Thislets the thermocouple warm up. If not,the gas supply is interrupted.3. Adjust the flame after it is regular.If after some tries the burnerdoes not light, check if thecrown and its cap are incorrect positions.WARNING!Do not keep the control knobpushed for more than 15seconds. If the burner doesnot light after 15 seconds,release the control knob, turnit into off position and try tolight the burner again afterminimum 1 minute.CAUTION!In the absence of electricityyou can ignite the burnerwithout electrical device; inthis case approach theburner with a flame, turn thecontrol knob counter-clockwise to maximum gassupply position and push itdown. Keep the control knobpushed for equal or less than10 seconds to let thethermocouple warm up.If the burner accidentallygoes out, turn the controlknob to the off position andtry to light the burner againafter minimum 1 minute.The spark generator can startautomatically when youswitch on the mains, afterinstallation or a power cut. Itis normal.4.3 Turning the burner offTo put the flame out, turn the knob to theoff position .WARNING!Always turn the flame downor switch it off before youremove the pans from theburner.5. HINTS AND TIPSWARNING!Refer to Safety chapters.www.electrolux.com8