USE AND FUNCTIONING494Default SettingsThe following tables contain the default values for the major barcode setupparameters, according to the type of scan engine mounted on the mobile computer.For a complete list of parameters and of their configuration procedures, please referto the SDK Help file on the CD.SCAN PARAMETERS LASERMODELSIMAGERMODELSScanTimeout 5000 Not availableBeepType Dual tone Not availableBeepDuration 20 Not availableBeepFrequency 2000 Not availableGoodReadSound Beep Beep.wavLedDuration 200 ms 200 msLedPulses 1 1ContinuousMode Disabled DisabledKeyboardEmulation Enabled EnabledSoftTrigger Enabled EnabledScanAlwaysOn Disabled DisabledGreenSpotDuration 1000 Not availableNotPrintableChar Leave LeaveScanButton Enabled EnabledBARCODE SYMBOLOGYSPECIFIC READERPARAMETERSLASERMODELSIMAGERMODELSUPC A Enabled∗UPC E EnabledEAN 8 EnabledEAN 13 EnabledUPC/EAN/JAN Not available EnabledCode 39 Enabled EnabledCode 39 Full ASCII Disabled DisabledCode 32 Disabled Not available2/5: Interleaved Enabled Enabled2/5: Industrial Disabled Not available2/5: Matrix Disabled Not availableCode 128 Enabled EnabledEAN 128 Enabled DisabledCODABAR Disabled Enabled∗ In the Imager models these codes may only be enabled or disabled as a group by the UPC/EAN/JAN familyselection (see a few lines below).
