Dacor EWD24 Installation Instructions Manual

Also see for Epicure EWD24: Use and care manual Use and care manual Installation instructions Use and care manual Planning guide

Contents

Dacor EWD24 Installation Instructions Manual Manual pdf 9 page image

7WARNINGTo avoid personal injury caused by the appliance•falling forward when the drawer is opened, securethe chassis to the cabinet and support platform asinstructed.Be certain that the power plug is disconnected from•the electrical outlet before installation.Verify that the electrical supply matches the ratings•found on the appliance data plate and the installationspecifications before proceeding.Remove the DrawerRemove the drawer from the appliance to allow accessto the mounting holes during installation, and toreduce weight:Pull the drawer out to the fully open position.1.Push in on the locking tab on one side as you pull the2.drawer up.When the drawer comes loose from the slide, repeat3.the same process on the opposite side.Grip the drawer on both sides and pull it free.4.For safety, push both drawer slides into the drawer5.opening.Installation InstructionsInstalling the ChassisGrasp the warming drawer chassis on opposite1.sides and slide it partially into the cabinet opening.Temporarily support the chassis in place so that it willnot tilt or fall.From an adjoining cabinet, reach in behind the drawer2.and pull the power cord until the plug is next to theelectrical outlet. Do not plug in the power cord at thistime.After positioning the power cord and plug, slide the3.chassis completely into the cabinet until the front frameis positioned flush against the cabinet face.Use the screws provided to secure the warming drawer4.chassis to the cabinet and support platform, insert theminto the mounting holes and tighten into place. You maywant to drill pilot holes prior to installing the mountingscrews.StEP 2: Pushlocking tabStEP 3: Pull up onfront of drawerMounting Hole,9 PlacesContinued...

/ 12

Related manuals for Dacor Epicure EWD24