Dacor EF42DBSS Use And Care Manual

Also see for EF42DBSS: Use and care manual Dimensions Planning guide Installation instructions Use and care manual

Contents

Dacor EF42DBSS Use And Care Manual Manual pdf 11 page image

9To Remove and Replace the Ice Storage Bin(dispensing models):Hold the base of the storage bin (located on the back of the1.freezer door) with both hands and press the release button tolift the storage bin up and out.NOTE: It is not necessary to turn the ice maker control tothe OFF (right) position when removing the storage bin. Thesensor cover (“flipper door”) on the left wall of the freezerstops the ice maker from producing ice if the door is open orthe storage bin is removed.Replace the storage bin on the door and push down to make2.sure it is securely in place.Clean the Ice Storage BinNOTE: It is normal for ice to stick together in the ice bin. Ice maybe dispensed or used more frequently which will break up the ice.It is recommended that the ice container be emptied and cleanedas needed.To clean the ice storage bin:Empty the ice container. Use warm water to melt the ice if1.necessary.NOTE: Do not use anything sharp to break up the ice in thebin or bucket. This can cause damage to the ice container andthe dispenser mechanism.Wash ice bin with a mild detergent, rinse well and dry2.thoroughly. Do not use harsh or abrasive cleaners or solvents.IMPORTANT:Allow 24 hours to produce the first batch of ice. Allow 3 daysto completely fill ice container. Before using the ice, fill anddiscard two full containers of ice to prepare the filter for use.The quality of your ice will be only as good as the quality ofthe water supplied to your ice maker.Avoid connecting the ice maker to a softened water supply.Water softener chemicals (such as salt) can damage parts ofthe ice maker and lead to poor quality ice. If a softened watersupply cannot be avoided, make sure the water softener isoperating properly and is well maintained.It is normal for the ice cubes to be attached at the corners.They will break apart easily.For non-dispensing models, do not force the ice maker wireshutoff arm up or down.Do not store anything on top of the ice maker or in the icestorage bin/bucket.Refrigerator OperationTo Remove and Replace the Ice Bin (non-dispensingmodels):Flip up the ice maker cover.1.Lift the wire shutoff arm so it clicks into the off (up) position.2.Ice can still be dispensed, but no more can be made.Lift up the front of the storage bin and pull the ice bin forward.3.Replace the bin by pushing it in all the way or the dispenser4.will not work. Push the wire shutoff arm down to the onposition to restart ice production. Make sure the door is closedtightly.Dispensing ModelsTo Turn the Ice Maker On/Off:The On/Off switch is located on the top right side of the freezer1.compartment.To turn the ice maker on, slide the control to the2. ON (left)position.NOTE: Your ice maker has an automatic shutoff. The icemaker sensors will automatically stop ice production, but thecontrol will remain in the ON (left) position.To manually turn the ice maker off, slide the control to the3. OFF(right) position.Ice MakerABA. Ice maker coverB. Ice bin