DGS-6604 m show ip pim rp mappingCLI Reference Guide 668show ip pim rp mappingUse this command to show group-to-RP (rendezvous point) mappings, and theRP set.show ip pim rp mappingSyntax NoneDefault NoneCommand Mode User EXEC or any configuration modeUsage Guideline Use this command to display active rendezvous points (RPs) that are cachedwith associated multicast routing entries.This command is used to display the RP mapping information viewed by therouterExample The following is sample output from the show ip pim rp mapping command withthe group address 239.1.1.1 specified:Display FieldDescriptionsThe table below shows the ip pim rp mapping detailed field descriptions.Switch#show ip pim rp mappingPIM Group-to-RP MappingsGroup(s): 224.0.0.0/4RP: 90.1.1.3Info source: 90.1.1.3, via bootstrap, priority 0Uptime: 0DT16H52M39S, expires: 0DT0H2M50SField DescriptionsRP Address of the RP for the group specified.Info source Indicates from which system the router learned this RP information. RP wasselected by the bootstrap mechanism. In this case, the BSR is also the RP.Via bootstrap The RP mapping information is learned from RP.Priority The RP priorityUptime Length of time that the router has known about this RP.Expires Time after which the information about this RP expires. If the router does notreceive any refresh messages in this time, it will discard information about thisRP.
