5 Surveillance Mode Configuration D-Link Smart Managed Switch User Manual113333Note: Switch will reboot after restore, andall current configurations will be lost.Firmware Backup and UpgradeAllow for the firmware to be saved, or for an existing firmware file to be uploaded to the Switch. Two methodscan be selected: HTTP or TFTP.Figure 5.22 – Surveillance Mode > Tools Menu > Firmware Backup & UpgradeThe fields that can be configured with HTTP section are described below:Parameter DescriptionBackup/Restore Image IDnumber: Select Image_id 1 or Image_id 2 to backup or restore the firmware file.Click Backup to save the firmware to your disk.Click Choose File to browse your inventories for a saved firmware file.Click Upgrade after selecting the firmware file you want to restore.The fields that can be configured with TFTP section are described below:Parameter DescriptionBackup/Restore Image IDnumber: Select Image_id 1 or Image_id 2 to backup or restore the firmware file.TFTP Server IP Address Specifies the IPv4 or IPv6 Address to be used.TFTP File Name Choose the file name for the firmware file you want to save to / restorefrom.Click Backup to save the firmware to the TFTP server.Click Upgrade after selecting the firmware file you want to restore.Note: Do not disconnect the PC or remove the power cordfrom device until the upgrade completes. The Switch maycrash if the firmware upgrade is incomplete.Firmware InformationThe Firmware Information page displays the information of firmware. The user can specify configuration IDand image file to boot up when power on the Switch next time.
