D-Link DCS-1000 Manual

Also see for Air DCS-1000W: Supplementary guide Installation guide Quick installation guide Brochure Manual

Contents

75need to first disconnect the Internet Camera from the network. Then run thePING utility (follow the instructions in Appendix B - PING Your IP Address.)A2: Another possible reason is the IP Address is located on a different subnet.To fix the problem, run the PING utility (follow the instructions in Appendix B -PING Your IP Address). If the utility returns “no response” or similar, the findingis probably correct, then you should proceed as follows:In Windows 95/98/2000 and Windows NT, check that the IP Address of theInternet Camera is within the same subnet as your workstation. Click Start, Setting, Control Panel, and the Network icon. Select TCP/IP from the Network dialog box and from the TCP/IPProperties dialog box click on Specify an IP address. If the Internet Camera is situated on a different subnet than yourworkstation, you will not be able to set the IP address from this workstation.To verify make sure the first 3 sections of the IP address of the InternetCamera corresponds to the first 3 sections of the workstation. Thereforethe IP address of the Internet Camera must be set from a workstation onthe same subnet.A3: Other possible problems might be due to the network cable. Try replacingyour network cable. Test the network interface of the product by connecting alocal computer to the unit, utilizing a standard Crossover (hub to hub) Cable. Ifthe problem is not solved the Internet Camera might be faulty.Q: Why does the Power LED not light up constantly?A: The power supply used might be at fault. Confirm that you are using theprovided power supply, which is DC 5V, for the Internet Camera and verify thatthe power supply is well connected.Q: Why does the LAN/WLAN LED not light up properly?A1: There might be a problem with the network cable. To confirm that the cablesare working, PING the address of a know device on the network. If the cablingis OK and your network is reachable, you should receive a reply similar to thefollowing (…bytes = 32 time = 2 ms).A2: The network device utilized by the Internet Camera is not functioning properly,such as hubs or switches. Confirm the power for the devices are well connectedand functioning properly.