Craftsman SP5373 Owner's Manual

IIIILui_MOUNTING INLET BRACKET1, Locate the following items from the loose parts bag:Description Qty.A Flat Washers* (5/16x 11/16xl/!6) ..... 2B Hex Screws* (M8 x 1.25 - 12) ............... 2C Flat Washers *(1/4 x 1/2) ...................... 2D Hex Screws* (M6 x 1 - 12) ................... 22, Insert Inlet Bracket between relief flange of InletGuard and against inside edge of angle flange onSupport Leg. Make sure both holes on Bracket alignwith similar holes on Leg Support.3. Place 5/16 flat washer on hex screw, insert throughLeg hole and attach to threaded hole of Bracket,4. Repea! same process for other hole and secure withuse of adjustable wrench.5. Attach Fixed Clamp as shown, by plac}ng flat washeron hex screw, insert hex screw through hole of FixedClamp and attach to threaded hole of /nfet GuardBracket.6. Repeat step 5 to attach other screw below InletGuard.7. Tighten all screws on Legs, Inlet Guard, and FiltrationHousing secu rely,LIIIiiiiiiiiiiiiijljl iiii, iii ii i ii iiA R* Items are shown actual sizec DMOUNTING BASE PLATE1. Locate the following items from the loose parts bag:Description Qty.A Flat Washers* (5/I_6x 11/16xl/16) ..... 4B Hex Screws* (M8 x 1.25 - 12) ............... 42. Attach Base Plate to Leg Supports by flipping baseupside down, aligning holes on both Leg Supports.A B* Items are shown actual sizeF_XED CASTERS3. Place flatwasher on hex screw, insertthrough hole ofLeg and attach to threaded holes in Base Plate asshown.4, Repeat same process for other three holes andsecure with adjustable wrench.5. With the assistance of another person, carefully flipthe Dust Collection System right side up._ "- _,._-- FLA'[ WASHER_:f -I J_, _"ill _ A_HEx SCREWiF" _ _ LEa!i _ _ SUPPORTii9