General SetupRead operator’s manual and follow all SafetyRules and instructions before operating thisequipment.778-120041Insert handle into thehandle mounting bracket.Install the hardware asshown.BlackRedAttachingHandle AssemblyAttaching theCablesCartonRemoval25Connect the reverse (red)cable to the reverse cablecontrol. Connect the forwarddrive (black) cable to theclutch bail.In order to move the tillerwithout the engine engaged,the wheels must beunlocked. Remove the clickpin from the wheel hub.36Snap the red cable into thetop position on the handleassembly mount and theblack cable into the bottomposition.Slide the wheel fully inwardon the wheel shaft. Reinstallthe click pin.NOTE: Images shown are for references only. Your individual tiller may have different features than those shown. Please refer to operator’s manual.Oil GasYou must ADD OIL beforeoperating tiller.Slowly pour entire bottle ofoil provided into the oil fillspout. Replace and tightendipstick.Fill fuel tank to bottom oftank filler neck.Use fresh, regular unleadedgasoline with a minimum of87 octane. Do not add E85gasoline.7 8Attachingthe CablesClip the cables into thecable guides on the handleassembly panel.4BlackRedCartonRemovalUse the handlebar to liftand pull the tiller off theshipping platform.To use the tiller, return thewheels to their originalposition with the pinsthrough the wheel hubsand wheel shafts beforestarting the engine.Refer to operator’s manual.ClutchBailGasolineFiller CapReverse CableControlEngineOil Cap