CUSTOMER RESPONSIBILITIESDO NOT REMOVE OR INSTALL COVER WHILEMOTOR IS RUNNING. THE COVER PROTECTSYOU FROM MOVING PARTS, WHICH COULDCATCH HANDS, HAIR OR CLOTHING ANDCAUSE SERIOUS INJURY.TO REMOVE MOTOR COWL (FIG. 16)• Push down hard on cowl (A) and tum cowl releaselever (B) on rear of motor (Figure 16).• Lift cowl up in rear (C) and move cowl to front tofree it from cowl retainer. Lift cowl up and off.TO INSTALL MOTOR COWL (FIG, 16)• Place cowl retainer into slot (A) in front of motorcowl (Figure 16).• Push cowl back slightlyover seal.• Push down and tum release lever (B) to lockcowlin place.AREMOVALBI NSTALLATIO NAFigure 16AVOID SPILLING FUEL AND KEEP ALLSOURCES OF HEAT, FLAME AND SPARKSAWAY WHEN DISCONNECTING, HANDLINGOR STORING FUEL SYSTEM COMPONENTS.CHECK/REPLACE FUEL LINE FILTER(FIG.17)• Remove motor cowl.• Inspect fuel linefilter (A). If the filter appears con-taminated, remove and replace the filter.AFigure17CLEAN/REPLACE FUEL TANK RLTER(FIG.18)• Disconnect fuel line from motor.• Remove fuel connector (A) from fuel tank (Figure18).• Remove fuel filter (B) from bottom of pick-up tube.• Wash filter in clean solvent.• Replace filter if rusted, corroded or damaged.• Reinstall fuel tank adapter and reconnect fuel=line.ij BFigure 18. ">N -