OneStart

Menu
Craftsman CMXGLXT2700 Instruction Manual Manual pdf 6 page image

Craftsman CMXGLXT2700 Instruction Manual

Page 1 previewPage 2 previewPage 3 previewPage 4 previewPage 5 previewPage 6 previewPage 7 previewPage 8 previewPage 9 previewPage 10 previewPage 11 previewPage 12 previewPage 13 previewPage 14 previewPage 15 previewPage 16 previewPage 17 previewPage 18 previewPage 19 previewPage 20 previewPage 21 previewPage 22 previewPage 23 previewPage 24 previewPage 25 previewPage 26 previewPage 27 previewPage 28 previewPage 29 previewPage 30 preview
Craftsman CMXGLXT2700 Instruction Manual Manual pdf 6 page image
6STEP 6: Attach Control Lever6.1 Remove the spring cotter pin and the retaining pin from the control valve. Rotatethe control lever to the vertical position and secure with the retaining pin and thespring cotter pin.7.1 Attach the log cradle (59) to the beam with the Ø12 flat washer (63) and the M12 nylonlock nut (12) using a 19mm wrench.STEP 7: Attach the Log CradleSpringCotter PinRetaining PinControl Lever 8.1 Make sure the log splitter is on a level surface.8.2 Remove the oil fill cap/dipstick to check the oil level.8.3 Refer to the separate the engine’s user manual to determine the necessary quantity ofengine oil; add engine oil to the proper level and replace the oil fill cap/dipstick.8.4 Check the engine oil level daily and add oil as necessary to maintain the proper level.STEP 8: Add Engine OilNOTICE: During the break-in period check the engine oil level often. When initially usingthe log splitter the operator should check the engine oil level frequently to ensure properfunction.DO NOT attempt to crank or start the engine before it has been properly filled with therecommended type and amount of engine oil. Damage to the log splitter resulting from afailure to follow these instructions will void the warranty.631259STEP 9: Add Hydraulic Oil9.1 The log splitter needs to be on a flat level surface before adding the hydraulic oil.9.2 Remove the oil cap from the hydraulic oil tank.9.3 Add 3.7 gallons of hydraulic oil AW32, AW46 & universal hydraulic oil are allacceptable types of fluid.9.4 Start the engine and use the control lever to extend and retract the wedge severaltimes to remove air from the lines.9.5 With the wedge retracted, check the hydraulic oil level again and fill if necessary.9.6 To enhance engine start up, automatic transmission fluid can be used whenoperating in temperatures below 32 degrees.
/ 30
Related manuals for Craftsman CMXGLXT2700
Craftsman CMXGLXT3200 Instruction Manual first page preview
Craftsman CMXGLXT3200 Instruction Manual
This manual is suitable for:
CMXGLXT2700
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved