Craftsman 390.2514 Owner's Manual

READ AND FOLLOW SAFETY INSTRUCTIONS!This is the safety aler'c symbol. When you see this symbol on yourpump or in this manual, look for one of the following signal wordsand be alert to the potential for personal injury:DANGER warns about hazards that will cause serious personalinjury, death or major property damage ff ignored.WARNING warns about hazards that will or can cause seriouspersonal injury, death or major property damage ff ignored.CAUTION warns about hazards that will or can cause minor per-sonal injury or property damage ff ignored.The label NOTICE indicates special instructions which are im-portant but not related to hazards.Carefully read and follow all safety instructions in thismanual and on pump.Keep safety labels in good condition.Replace missing or damaged safety labels.Relief valve must be capable of passing full pump flow at 75 PSI.Pump water onJy with this pump.Electrical SafetyWARNINGHazardous voltage.Can shock, burn, orcause death.Ground pump beforeconnecting to powersupply._k Wire motor for correctvoltage. See "Electrical"section of this manualand motor nameplate.Ground motor beforeconnecting to powersupply.Meet National Elect-rical Code and localcodes for all wiring._k Follow wiring instruc-tions in this manualwhen connecting mo-tot to power lines.Make workshops childproof; use padlocks and master switches;remove starter keys.General SafetyDo not allow pump, pressure tank, piping, or any other systemcomponent containing water to freeze. Freezing may damage sys-tem, leading to injury or flooding. Allowing pump or system com-ponents to freeze will void warranty.General SafetyWARNINGHazardous pressure!Install pressure reliefvalve in discharge pipe.Release all pressure onsystem before working onany component.Periodically inspect pump and system components.Wear safety glasses at all times when worldng on pumps.Keep work area clean, uncluttered and properly lighted; storeproperly all unused tools and equipment.Keep visitors at a safe distance from the work areas.A WARNIN__j Pump body may explode if used as a boosterpump unless relief valve capable of passing full pump flowat 75 PSI (517 kPa) is installed,fIax CAUTION !Motor normally operates at high temperature andwill be too hot to touch. It is protected from heat damage duringoperation by an automatic internal cutoff switch. Before handlingpump or motor, stop motor and allow it to cool for 20 minutes.TABLE I - PUMP PERFORMANCE (In Gallonsper Minute)Model Discharge Pumping Depth in FeetNo. Description Suct. Disch. Pressure PSI 5' 10' 15' 20'390.2514 1/2 HP S.W. Jet 1-1/4" 1" 40 8.2 7.3 6.2 5.0390.2518 3/4 HP S.W. Jet 1-1/4" 1" 40 10.9 10.4 8.6 7.52