Craftsman 247.77763 Owner's Manual

Also see for 247.77763: Owner's manual

Contents

Flange NutsWeldHex Nuts &Hex Bolts & Bell WashersSaddle WashersFigure 6• Place the chipper chute over the weld studskeeping the slottedside towards the bottom.Loosely secure with the three hex nuts and bell •washers that were removed earlier. Do not fullytighten the hex nuts at this point in the assembly.See Figure 7.Support'_ ! Chipper ..Bracket \\ II 1_ Chute_ Flange.uts\ _-_ _" __./_'_ _/_J_l-lexNuts&"_._ v _lOt / _/ BellWashersFigure 7• Align the supportbracket with the holes in therightside of the upper and lower handles wherethe hex boltswere just removed. Push upslightlyon the chipper chute in order to betteralign the holes in the supportbracket with theholes in the handles.• Replace the hex bolts,saddle washers andflange nuts.to affixthe support bracket to thehandle assemblies. See Figure 7.• Follow by tighteningall hardware-se_-urelyfirston the chipper chute, then on the supportbracket, and finally on the handle.Attaching the Catcher Bag• Place the catcher bag inside of handleassembly, Slip the opening on the bag over thedischarge chute, making certain it is over the ribon the dischargechute.Place the four straps on the top of the bag overthe upper handle, hooking them on the studs.Squeeze the clamp on the drawstring and pullthe drawstringtight. Release the clamp. SeeFigure 8,Discharge StudsChuteRibCatcher Bag/Drawstring StrapFigure 87

/ 10

Related manuals for Craftsman 247.77763