Craftsman 183.172540 Owner's Manual

SECTION PAGEWarranty ........................................ 2ProductSpecifications...................... 2PowerTool Safety ............................ 3CuttingToct & AccessorySafety ......... 4ElectricalRequirement& Safety .......... 5CuttingTootSymbols........................ 6SECTION PAGEACCSS_ .................................... 7Carton Contents .............................. 7 - 8Know Your Cutting Toct .................... 9 - 10Assembly & Operation ...................... 11 - 23Maintenance ................................... 24Repair Parts ................................... 25 - 36FULL ONE YEAR WARRANTYIf this Cutting Tool fails due to a defect in material or workmanship within one year of date ofpurchase, Sears will at its option repair or replace it free of charge.Return this Cutting Tool to a Sears Service Center for repair, or to place of purchase forreplacement.This warranty gives you specific legal rights, and you may also have other dghts which may varyfrom state to state.Sears, Roebuck and Co., Dept. 817 WA, Hoffman Estates, IL 60179[A WARNINGJSome dust created by power sanding, sawing, grinding, drilling and other construction activities containschemicals known (to the State of California) to cause cancer, birth defects or other reproductive harm. Someexamples of these chemicals are:• Lead from lead-based paints• Crystalline silica from bricks, cement and other masonry products• Arsenic and chromium from chemically treated lumberYour risk from these exposures varies, depending on how often you do this type of work. To reduce yourexposure to these chemicals, work in a well ventilated area and work with approved safety equipment such asthose dust masks that are specially designed to filter out microscopic particles,Motor Rating ...................... 120 V, 60 Hz, ACAmperes ........................... 5.0 ATwo Speeds (no load) ......... 20,000 & 30,000 RPMMotor Horsepower ...... 3/4 HP (Maximum Developed)Weight ..................... 3 lb. 12 oz, (1.7 kg)Maximum Disc SiZe .... 4" DiameterJ_ WARNING ITo avoid electrical hazards, fire hazards or damage to the tool, use proper circuit protection.This power tool is wired at the factory for 110-120 V operation. It must be connected to a 110-120 V 115 A timedelayed fuse or circuit breaker. To avoid shock or fire, replace power cord Immediately if it is worn, cut ordamaged in any way.Before using your cutting tool, it Is critical that you read and understand these safety rules, Failure to followthese rules could result in serious Injury to you or damage to the cutting tool.2