Craftsman 172.79183 Operator's Manual

Also see for 172.79183: Operator's manual

ATTACHING THE HANDLEThe _handlecomes packaged in sections,which are connectedtogether by internalcoatedwiring ru_ningthroughthe middle of all the handle pieces.• 1, Carefuily remove packingmaterialand plasticwPappingaroundtool and handle pieces,being carefulto keep pieces connected.2. Remove the Knobs and Curved Head Boltsfrom the plastic bag.3, Remove the black plastic tube coating from the piece of wire between the Handle andthe Upper Tube (Fig.l). This willenable the bolttofit throughthe smaller diameterHandle.4. Slide the Handle down into the end of the Upper Tube so the holes lineup (Fig. 3a).Carefully insert bolt, beingca'refulto avoid coveredwire _nsidehandle shaft (Fig. 3b).Fasten together by tighteningKnobonto Curved Head B01t.5. Slide UpperTube down into LowerTube so that holes line up. De n_t removethe blackplastt_tube coatingfrom the wire at this¢onnecti(_n;Themare two positloP_savailable foradjustment-t0your pmlerred height (FigAa).=NOTE: When you fkst ir_sertthe bolt,it may be necessary to wiggleit _amfully to get _ pastthe coated wire inside theTube. Fasten together with second,Knob and Cu_ed Head Bolt(Ftg.4b).Fig.3bFig. 4a Fig. 4bINOTE= Be sure the wire cane movessmoothl, down into the Lower Handle.TubeWhile assembling. :_• % H,¢l i ,,., r i ....... " . .t...._:CAUTION= NEVER .so aslta:rp objeot to move ¢oated wires oUt of the wayo I13