Menu
Craftsman 171.254841 Owner's Manual
                                                        |
FENCE TO THE ROUTER TABLE1. Refer to Steps 4 through 8 and Figure !4a onPage 12.2. Adjust fence to desired location to obtain requiredcut.NOTE IThere are two scales, with 1/16" increments, moldedinto the top of the router table to aid you in adjustingthe location of the fence.4. TIGHTEN the knobs when the fence assembly isaligned at the desired location.WET/DRY VAC TO THE FENCEThe router table fence assembly has a port at theback where a wet/dry vac hose can be connected.The port will accommodate a 2-1/2" diameter hosenozzle.To attach, push the nozzle into the port while holdingthe fence in place.,_CAUTION IOperating the router table without a wet/dry vac canresult in an excessive collection or build-up of saw-dust and chips under the fence assembly and theoverhead guard. This can hinder the performance ofthe router table and the fence assembly.RECOMMENDATION: Regardless of whether awet/dry vac is being used, remove the sawdust andwood chips from under the fence assembly and theoverhead guard as needed. This removal should bedone so that the performance of either is not hin-dered.RECOMMENDATION: It is always a good practice tokeep the work area clean. As necessary, remove thesawdust and wood chips from the top of the routertable, as well as any that has accumulated on thefloor around the router table.,_WARNINGWhen doing the above, keel_ the following in mind:o The ROUTER and THE SWITCH must be turnedOFF.o The router bit must NOT be turning.• The router power cord must be UNPLUGGEDfrom the switch.• The power cord from the switch must beUNPLUGGED from the extension cord.16 |
Related manuals for Craftsman 171.254841
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved