Craftsman 152.211640 Owner's Manual

Fig. C G HEC ...................................mN \j KLU$UNPACKING AND CHECKINGCONTENTS (Fig. C)This Bench Grinder will require a minimal amount ofassembly, A 12mm x lOmm open end wrench isprovided for mounting the Tool Rest Assemblies andthe Spark Arrestor Assemblies,1, Remove parts from all of the cartons and lay themon a clean work surface,2, Remove any protective materials and coatings fromall of the parts and the bench grinder, The protec°tive coatings can be removed by spraying WD°40on them and wiping it off with a soft cloth, This mayneed to be redone several times before all of theprotective coatings are removed completely,CAUTION: DO NOT use acetone, gasoline orlacquer thinner to remove any protective coatingson your bench grinder,3, Compare the items to Figure C; verify that all itemsare accounted for before discarding the shippingbox, if there are any missing parts, call CustomerHelpline 1°800°897°7709,To avoid serious injury, do not attempt to plug in thepower cord and turn "ON" the Bench Grinder if anyparts are missing, The Bench Grinder can only beturned "ON" after all the parts have been obtained andinstalled correctly,The following items are to be provided in the shippingbox:A, Grinder (not shown)B, Eyeshield (2)C, Carriage head screw M6 x 80mm (2)D, Spacer (2)E, Fiat Washer M6 (2)R Eyeshield knob (2)G, Wheel dresserH, Hex head screw 5/16o18 x 1/2" (4)I, Fiat washer 5/16" (4)J, Spark arrestor, leftK, Spark arrestor, rightL, Fiat washer 1/4" (2)M, Hex head screw 1/4o20 x 1/4" (2)N, Tool rest support, leftO, Tool rest support, rightR Tool rest, rightQ, Drill bit sharpening plateR, Tool rest knob (2)S, Fiat washer 5/16" (2)T, Tool rest, leftU, Special wrench