Craftsman 139.30499 Instructions Manual

Contents

replacement parts

3-BUTTON REMOTE CONTROL MODEL 139.30499Compatible with 315 MHz or 390 MHzgarage door openers manufactured afterJanuary 1, 1993. Make sure the garagedoor opener has a working light bulbbecause it is a programming indicator.Locate the Program button onthe remote control.Program ButtonLocate the Learn button onthe garage door opener.NOTE: Your garage dooropener may look different.OR ORGreen orRed/Orange Purple YellowLearnLEDLearnLED LearnLEDPREPAREPROGRAM THE REMOTE CONTROL1 2 3To enter programmingmode, press the Programbutton until the LED on thefront of the remote controlturns on.4 5Safety Pin orPaper ClipPress and release theLearn button onthe garage dooropner.The Learn LED will light.Within 30 seconds...Press and release the remotecontrol button you want to use...Check to see if the garage door openerlight bulb blinks. If not, wait for theremote control LED to light solid thenslowly press and release the remotecontrol button again. Repeat until thelight bulb blinks.DO NOT press the button after thelight bulb blinks.To exit programming mode, pressany remote control button exceptthe button that was just programmed.The garage door openerwill activate.To test, press the programmed button on the remote control...BATTERYThe LED on your remote willstop flashing when thebattery is low and needs tobe replaced.To replace battery, open thecase as shown. Insertbattery positive side up (+).Replace the battery withonly 3V2032 coin cellbatteries. Dispose of oldbattery properly. REPLACEMENT PARTSBattery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10A20To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door:• ALWAYS keep remote controls out of reach of children. NEVER permit children to operate or playwith remote controls.• Activate gate or door ONLY when it can be seen clearly, is properly adjusted and there are noobstructions to door travel.• ALWAYS keep gate or garage door in sight until completely closed. NEVER permit anyone to crosspath of moving gate or door.To prevent possible SERIOUS INJURY or DEATH:• NEVER allow small children near batteries.• If battery is swallowed, immediately notify doctor.To reduce risk of fire, explosion or chemical burn:• Replace ONLY with 3V2032 coin batteries.• DO NOT recharge, disassemble, heat above 212° F(100° C) or incinerate.NOTICE: To comply with FCC and or IndustryCanada rules (IC), adjustment or modificationsof this receiver and/or transmitter are prohibited,except for changing the code setting orreplacing the batteryTHERE ARE NO OTHER USER SERVICEABLEPARTS.Tested to Comply with FCC Standards for Homeor office use. Operation is subject to thefollowing two conditions: (1) this device maynot cause harmful interference, and (2) thisdevice must accept any interference received,including interference that may cause undesiredoperation.

/ 2

Related manuals for Craftsman 139.30499