Craftsman 130.16491 Operator's Manual

Page 9OPERATIONWARNING: Do not use this tool for scaffolding or as a ladder. Make sure totighten all locking knobs and levers securely prior to use. Maximum capacity is330 lbs. Power tools on the stand should not exceed a combined overall heightof 60 inches from the floor.SET UP THE STAND1. Place the frame assembly withlegs (A) upside down on a flatsurface as shown in Fig. 2.2. To open the top two legs, pressthe locking pins and rotate thelegs until the locking pins snapinto the open position and youhear a “click” to signal that thelegs are locked in place (Fig. 3).3. Open and lock the other twolegs the same way.4. Place the frame assembly on aflat surface as shown in Fig. 4.MOUNTING A MITER SAWWARNING: Failure to unplugthe tool before attaching it to thestand could result in accidentalstarting and possibly seriouspersonal injury.WARNING: To avoid seriouspersonal injury,always make surethat miter saws are fully supportedand securely attached to a levelwork surface. If necessary,movethe stand to a location where it willbe more stable.WARNING: Do not mounta table saw on this stand. Thedirection of feed on a table saw isperpendicular to the axis of stabilityon this stand. Aggressive feedingof sheet materials into a table sawcould cause the stand to tip over.Fig. 2AFig. 4Fig. 3Press lockingpin to move legMA16491 Manual_Revised_18-0828