Craftsman 113.23800 Owner's Manual

Contents

12. Replace the Lathe pulley. Position it so that the end ofthe pulley is ftush with the end of the lathe spindle.t3. Place the motor pulley on the motor shaft so that thesmall diameter is approximately t/16" away from motor.14. NOTE: When installing the pulley on a 5/8" diametermotor shaft, make sure that the 3/16" square key fur-nished with your motor is in place. Then tighten thesetscrew with a 5/32" setscrew wrench.//3/16 x 3/16 KEY15. When installing the pulley on a 1/2" diameter motorshaft, make sure that the adapter sleeve and 3/1 6"square key furnished with your motor are in place. Thentighten the setscrew with a 5/32" setscrew wrench.16. Place the belt on the pulleys and push the motor towardthe back until all the slack is removed from the belt.Tighten only two of the motor mounting bolts using a7/16" wrench.ADAPTER SLEEVE1/2 DtA. MOTOR SHAFT17. Place a straightedge such as a piece of wood, metal orframing equare across the pulleys to see if they are bothin line. If they are, tighten the other two motor mountingbolts. If they are not in fine, loosen the two motor boltsand move the motor sideways.., tighten the bolts.18. Find four pan head wood screws 1/2" tong from amongthe loose parts./Attach the belt guard plate to the bench with the twoscrews. Make sure the plate is PARALLEL to the belt.