Craftsman 113.22521 Owner's Manual

CABLE MOTORIANGER CORD6 Route the motor cord behind the motor mount,across the top of the base and plug it into the recep-tacle in the bottom of the switch box7 Bring the power cord alongside the motor cordwrap the plastic cable hanger around the cords andattach the hanger to the top of the basePOWE RCORDINSTALLING WORK TABLERemove the protective coating, that is applied at the fac-tory, from the work table Use any ordinary householdtype grease and spot removerCAUTION: Never use gasoline, naptha, or similar highlyvolatile solventsNOTE: Apply acoat of paste wax to the work table Thiswill help prevent rust and make it a little easier to feedthe work1 Loosen the table positioning screw2 Insert the table support rod in the hole in the baseuntil the edge of the table is approximately 1/16"from the abrasive disc. Tighten the screw,NOTE: There isa second mounting hole in the base Thisis for mounting the table when the belt is used in a ver-tical positionSECONDMOUNTINGHOLE TABLETABLE SUPPORTPOSITIONING RODSCREW15