Craftsman 113.213151 Owner's Manual

Contents

motor specificationsand emectricamo pE nCAT O.sThis drill press is designed to use a 1725 RPM motoronly, Do not use any motor that runs faster than 1725RPM It is wired for operation on 110-120 volts. 60 Hz.alteinat ng current.WARNING: To avoid injury from unexpectedstartup, do not use blower or washing machine Imotors or any motor with an automatic reset Ioverload protector. ICONNECTING TO POWERSOURCE OUTLETThis machine must be grounded while in use to protectthe operator from electric shock.Plug power cord into a 110-120V properly groundedtype outlet protected by a 15-amp. dual element timedelay or Circuit breaker.Not all outlets are properly grounded. If you are notsure that your outlet, as pictured below, is properlygrounded, have it checked by a qualified electrician.WARNING: To avoid electric shock, do not touch Ithe metal prongs on the plug, when installing orremoving the plug to or from the outlet.WARNING! Failure to properly ground thisIpower tool can cause electrmution or seriousshock, particularly when used in damp loca-tions, or near metal plumbing;if shocked, yourreaction could cause your hands tohit the cut-ring tool.'if power cord is worn or cut, or damaged in anyWay, have it replaced immediately to avoicshock or fire hazard.3-PRONGPLI IGALWAYS USE APROPERLY GROUNDEDOUTLETrequirementsTh!s powe_ too! is equipped with a 3-conductor cordand grounding type plug, approved by Underwriters'Laboratories and the Canadian Standards Association.The ground conductor has a green jacket and is at-tached to the toot housing at one end and to the groundprong in the attachment plug at the other end.This plug requires a mating 3-conductor grounded typeoutlet as shown,if the outlet you are planning to use for this power toolis of the two prong type, DO NOT REMOVE OR ALTERTHE GROUNDING PRONG IN ANY MANNER. Usean adapter as shown and always connect the groundinglug to known ground.It is recommended that you have a qualified electricianreplace the TWO prong outlet with a properly groundedTHREE prong outlet.An adapter as shown below is available for connectingplugs to 2-prong receptacles,WARNING: The green grounding lug extending 1from the adapter must be connected to a perma- tnent ground such as to a proper_y groundedoutlet box.GROUNDING LUGSCR_,,., \3-PRONG _ _ MAKE SURE THIS ISADAPTERNOTE: The adapter illustrated is for use only if youalready have a properly grounded 2-prong receptacle.Adapter is not allowed in Canada by the Canadian Elec-trical Code.The use of any extension cord will cause some loss ofpower. To keep this to a minimum and to prevent over-heating and motor burn-out, use the table below todetermine the minimum wire size (A.W.G) extensioncord. Use only 3 wire extension cords which have 3-prong grounding type plugs and 3-pole receptacleswhich accept the tools plug.Your unit is for use on less than 120 volts. It has a plug Extension Cord Length Wire Size A.W.Gthat looks like the one above, 0-25 Feet 162_50 Feet 165i-100 Feet 12