Cisco WS-SUP720= - Supervisor Engine 720 Configuration Manual

Also see for 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion: Solution guide Quick reference guide Manual Description Guide

Contents

switching modes

C H A P T E R4-1Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide, Release 12.2SXFOL-3999-084Configuring a Supervisor Engine 720This chapter describes how to configure a Supervisor Engine 720 in a Catalyst 6500 series switch. Thischapter contains these sections:• Using the Bootflash or Bootdisk on a Supervisor Engine 720, page 4-2• Using the Slots on a Supervisor Engine 720, page 4-2• Configuring Supervisor Engine 720 Ports, page 4-2• Configuring and Monitoring the Switch Fabric Functionality, page 4-2Note • For complete syntax and usage information for the commands used in this chapter, refer to the CiscoIOS Master Command List, Release 12.2SX at this URL:http://www.cisco.com/en/US/docs/ios/mcl/122sxmcl/12_2sx_mcl_book.html• With a 3-slot chassis, install the Supervisor Engine 720 in either slot 1 or 2.• With a 6-slot or a 9-slot chassis, install the Supervisor Engine 720 in either slot 5 or 6.• With a 13-slot chassis, install the Supervisor Engine 720 in either slot 7 or 8.Tip For additional information about Cisco Catalyst 6500 Series Switches (including configuration examplesand troubleshooting information), see the documents listed on this page:http://www.cisco.com/en/US/products/hw/switches/ps708/tsd_products_support_series_home.html