Cisco WIC-1ENET - 1700 Access Routers 1port10bt Enet Wan Interface(man Configuration Manual

Also see for 1700 series: Manual Application note Quick reference guide Quick reference guide Manual

Contents

Corporate Headquarters:© 2005 Cisco Systems, Inc. All rights reserved.Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USAConfiguring a Single-Port Ethernet WIC on aCisco 1700 Series RouterThe Cisco WIC-1ENET is a single-port Ethernet interface card supporting 10BASE-T Ethernet. Thecard provides the Cisco 1700 series router with additional Ethernet interfaces.Figure 1 shows the Cisco WIC-1ENET interface card.Figure 1 Cisco WIC-1ENET Interface CardThe LNK (physical layer link) LED is on when the IOS recognizes the Cisco WIC-1ENET card and theconnection is up. The FDX LED is on when the port is operating in full-duplex mode, and off whenoperating in half-duplex mode. Additionally, the Activity LED on the front of the Cisco 1700 seriesrouter indicates that data is transmitted or received on the slot.Note The Cisco 1700 Router Hardware Installation Guide provides procedures for physical installation.Although those instructions are for a WAN interface card (WIC), the procedures also apply to installingthis card.This document contains the following sections:• Cisco WIC-1ENET Requirements• IOS Commands• Caveats• Related Documents• Safety WarningsWIC1ENETFDXSEE MANUALBEFOREINSTALLATIONLNK10BT ETHERNET45789