Menu
Cisco TelePresence Touch Installation Manual
  |
A Connecting the touch screen via LANThe touch screen can be connected to the following codecs via LAN. The codecmay be part of a Profile system.• Codec C20• Codec C40• Codec C60• Codec C90Check the system information page on your codec to make sure its softwareversion is TC4.1 or later. If not, contact your Cisco representative.1. Restart the codec before you proceed with the installation.2. Connect the touch screen cable to the Power adapter.3. Connect the shielded Ethernet cable between the Power adapter and the LAN(Ethernet) socket.4. Connect the supplied power cable between the Power adapter and the powersocket. Once power is connected, the touch screen start-up procedure begins.Wait while the touch screen initializes. Continue when the Select codec to pairwith window appears. This may take a few minutes.Note: The touch screen obtains its IP settings automatically from the network(DHCP). In most cases this is preferred and you can continue with the pairing.If you need a static IP address for your touch screen perform the steps described inthe Change the IP settings section, before continuing.7.5 m5 mPoweradapterPower socketLAN socket(Ethernet)1.8 mA list of all codecs that are in Pairing mode is displayed on the touch screen.5. Click the codec name in the list.Note: If your codec is not in thelist, read about What to do if yourcodec is not listed below.6. Review codec details and clickStart Pairing to start the pairingprocess.7. If required, the touch screendownloads and installs newsoftware from the codec. Thetouch screen automaticallyrestarts after the softwareupgrade. This process may take afew minutes.If your codec is passwordprotected, you will be promptedfor an administrator usernameand password to sign in to thecodec.Continue when the menu andcontact list appear on the touchscreen.8. Verify that the touch screen is successfully paired to your codec by checking thecodec address displayed in the top banner.The touch screen is ready to use.Refresh listSelect codec to pair withSelect codec manually...IP SettingsSystem name (Codec type)name@company.comThe touch screenmenu and contact listAvailable name@company.com 12:00name@company.comProduct:Cisco TelePresence System CodecSIP URI:name@company.comH323 id:name@company.comSoftware:TC4.1.0IP address:192.168.1.128Serial number:CBA123456789System name (Codec type)name@company.comStart PairingBackThis box contains:• Cisco TelePresence Touch with cable (7.5 m / 25 ft)• Power adapter• Power cable (1.8 m / 6 ft) (included when Touch is shipped as a stand-alone unit)• Shielded Ethernet cable (5 m / 16 ft)• Cleaning clothCompatibilityThe touch screen is used with the Cisco TelePresence Codec C Series. Thesecodecs are also used in the Cisco TelePresence System Profile series. The touchscreen can be installed in two ways:A. Connecting the touch screen to a codec via LAN (local area network).B. Connecting the touch screen directly to the codec.Note: The codec software version must be TC4.1 or later.Safety requirementYou have to use a shielded Ethernet cable (as supplied).User documentationUser documentation for Cisco TelePresence products, including compliance andsafety information, is found on http://www.cisco.com/go/telepresence/docs.78-19948-01 JANUARY 2011.Copyright © 2010-2011 Cisco Systems, Inc. All rights reserved.Cisco TelePresence TouchFor C SeriesiNstALLAtioN guide |
Related manuals for Cisco TelePresence Touch
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved