Cisco PowerVu D9850 Quick Setup Instructions Manual

QUICK SETUP INSTRUCTIONSTV JAPANPowerVu D9850 Program ReceiverBefore you start, review the following information and enter your Receiver User Address:Program to receive: TV JAPANProgram Provider: NHK Cosmomedia America, Inc.Satellite & Transponder: Galaxy 13 4CPolarization: VerticalDownlink Frequency L-band 1350 (03.800 GHz)Symbol rate: 27.69 Msym/sNetwork ID: 8002FEC Rate: 3/4Receiver User Address (UA): (foundon the rear panel)Step-by-Step Instructions1. Connect the L-Band signal to the RF IN connector.Note that LNB power is only available via the RF input #1 for multiple RF models. Thefactory default setting for RF 1 LNB power is OFF. (If you need the receiver to poweryour LNB, details are provided in the User Manual shipped with the receiver.2. Connect video and audio outputs to monitors.3. Connect the AC power source. Wait for the receiver to fully boot up. Once ready, thedefault status menu will appear [CH:XXX Name:XXXX] For an initial installation, thechannel number will be 0 and the channel name will be “Not Available”.4. Press Menu to move from the initial display into the Main Menu system.5. Press the right arrow key so the cursor is to the left of the Preset/Input menu item.Press the Select button to display thePreset/Input menu.

/ 5

Related manuals for Cisco PowerVu D9850