Cisco DTA 170HD Quick Reference Manual

Also see for DTA 170HD: Installation guide

Cisco HD Digital Transport Adapter (DTA)Quick Reference GuideIMPORTANT SAFETY INSTRUCTIONSNotice to InstallersThe servicing instructions in this notice are for use by qualified service personnel only. To reduce the risk of electric shock, do not perform any servicing other than that contained in the operating instructions, unless you are qualified to do so.20080814_Installer820Note to System InstallerCAUTION: To reduce the risk of electric shock, do notremove cover (or back). No user-serviceable partsinside. Refer servicing to qualified service personnel.WARNINGTO PREVENT FIRE OR ELECTRIC SHOCK, DO NOTEXPOSE THIS UNIT TO RAIN OR MOISTURE.For this apparatus, the coaxial cable shield/screen shall begrounded as close as practical to the point of entry of thecable into the building. For products sold in the US andC a n a d a , t h i s r e m i n d e r i s p r o v i d e d t o c a l l t h e s y s t e minstaller's attention to Article 820-93 and Article 820-100 ofthe NEC (or Canadian Electrical Code Part 1), which providesguidelines for proper grounding of the coaxial cable shield.This symbol is intended to alert you that uninsulated voltagewithin this product may have sufficient magnitude to causeelectric shock.Therefore, it is dangerous to make any kind ofcontact with any inside part of this product.Ce symbole a pour but d’alerter toute personne qu’un contactavec une pièce interne de ce produit, sous tension et nonisolée, pourrait être suffisant pour provoquer un chocélectrique. Il est donc dangereux d’être en contact avec toutepièce interne de ce produit.This symbol is intended to alert you of the presenceof important operating and maintenance (servicing)instructions in the literature accompanying this product.Ce symbole a pour but de vous avertir qu’unedocumentation importante sur le fonctionnement etl’entretien accompagne ce produit.1) Read these instructions.2) Keep these instructions.3) Heed all warnings.4) Follow all instructions.5) Do not use this apparatus near water.6) Clean only with dry cloth.7) Do not block any ventilation openings. Install in accordancewith the manufacturer’s instructions.8) Do not install near any heat sources such as radiators, heatregisters, stoves, or other apparatus (including amplifiers)that produce heat.9) Do not defeat the safety purpose of the polarized orgrounding-type plug. A polarized plug has two blades withone wider than the other. A grounding-type plug has twoblades and a third grounding prong. The wide blade or thethird prong are provided for your safety. If the providedplug does not fit into your outlet, consult an electrician forreplacement of the obsolete outlet.10) Protect the power cord from being walked on or pinchedparticularly at plugs, convenience receptacles, and thepoint where they exit from the apparatus.11) Only use attachments/accessories specified by themanufacturer.12) Use only with the cart, stand, tripod, bracket, ortable specified by the manufacturer, or sold withthe apparatus. When a cart is used, use cautionwhen moving the cart/apparatus combination to avoidinjury from tip-over.13) Unplug this apparatus during lightning storms or whenunused for long periods of time.14) Refer all servicing to qualified service personnel. Servicingis required when the apparatus has been damaged in anyway, such as a power-supply cord or plug is damaged,liquid has been spilled or objects have fallen into theapparatus, the apparatus has been exposed to rain ormoisture, does not operate normally, or has been dropped.Power Source WarningA label on this product indicates the correct power source for this product.Operate this product only from an electrical outlet with the voltage andfrequency indicated on the product label. If you are uncertain of the typeof power supply to your home or business, consult your service provideror your local power company.The AC inlet on the unit must remain accessible and operable at all times.Ground the ProductWARNING: Avoid electric shock and fire hazard! If thisproduct connects to coaxial cable wiring, be sure the cable systemis grounded (earthed). Grounding provides some protection againstvoltage surges and built-up static charges.WARNING: Avoid electric shock and fire hazard! Donot locate an outside antenna system in the vicinity of overheadpower lines or power circuits. Touching power lines or circuitsmight be fatal.This product may contain a tuner capable of receiving off-the-airbroadcasts.Operating EnvironmentThis product is designed for operation indoors with a temperature rangefrom 32° to 104° F (0° to 40°C). Each product should have adequatespacing on all sides so that the cooling air vents on the chassis are notblocked.(Protect from Exposure to Moisture and Foreign Objects)Protect from Exposure to Moisture and ForeignObjectsWARNING: Avoid electric shock and fire hazard! Do notexpose this product to dripping or splashing liquids, rain, or moisture.Objects filled with liquids, such as vases, should not be placed onthis apparatus.WARNING: Avoid electric shock and fire hazard! Unplugthis product before cleaning. Do not use a liquid cleaner or anaerosol cleaner. Do not use a magnetic/static cleaning device (dustremover) to clean this product.WARNING: Avoid electric shock and fire hazard! Neverpush objects through the openings in this product. Foreign objectscan cause electrical shorts that can result in electric shock or fire.Service WarningsWARNING: Avoid electric shock! Do not open the coverof this product. Opening or removing the cover may expose youto dangerous voltages. If you open the cover, your warranty will bevoid. This product contains no user-serviceable parts.Check Product SafetyUpon completion of any service or repairs to this product, the servicetechnician must perform safety checks to determine that this product is inproper operating condition.Protect the Product When Moving ItAlways disconnect the power source when moving the apparatus orconnecting or disconnecting cables.20110316_Cable_SafetyCisco HD Digital Transport Adapter (DTA)Models: 170HD and 171HDManufactured by:Cisco Systems, Inc.5030 Sugarloaf ParkwayLawrenceville, Georgia 30044 USATelephone: 770 236-1077Open Source GNU GPL StatementCisco HD Digital Transport Adapter (DTA) contain(s), in part, certainfree/open source software (“Free Software”) under licenses whichgenerally make the source code available for free copy, modification, andredistribution. Examples of such licenses include all the licenses sponsoredby the Free Software Foundation (e.g. GNU General Public License (GPL),GNU Lesser General Public License (LGPL), Berkeley Software Distribution(BSD), the MIT licenses and different versions of the Mozilla and Apachelicenses). To find additional information regarding the Free Software,including a copy of the applicable license and related information, pleasego to: (i) for North America http://www.cisco.com/web/consumer/support/open_source.html, or (ii) for outside North America http://www.cisco.com/web/consumer/support/open_source.html#~international. Once at the site,search for the product listing and click on the related items identified. If youhave any questions or problems accessing any of the links, please contact:spvtg-external-opensource-requests@cisco.com.United States FCC ComplianceThis device has been tested and found to comply with the limits for a ClassB digital device, pursuant to part 15 of the FCC Rules. These limits aredesigned to provide reasonable protection against such interference in aresidential installation. This equipment generates, uses, and can radiateradio frequency energy. If not installed and used in accordance with theinstructions, it may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particularinstallation. If this equipment does cause harmful interference to radio ortelevision reception, which can be determined by turning the equipmentOFF and ON, the user is encouraged to try to correct the interference byone or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that towhich the receiver is connected.• Consult the service provider or an experienced radio/television technicianfor help.Any changes or modifications not expressly approved by Cisco Systems,Inc., could void the user’s authority to operate the equipment.The information shown in the FCC Declaration of Conformity paragraphbelow is a requirement of the FCC and is intended to supply you withinformation regarding the FCC approval of this device. The phone numberslisted are for FCC-related questions only and not intended for questionsregarding the connection or operation for this device. Please contact yourservice provider for any questions you may have regarding the operation orinstallation of this device.Declaration of ConformityThis device complies with Part 15 of FCC Rules. Operation is subjectto the following two conditions: 1) the device may not cause harmfulinterference, and 2) the device must accept any interference received,including interference that may cause undesired operation.AVC VIDEO LICENSEWith respect to each AVC/H.264 product, we are obligated to providethe following notice:THIS PRODUCT IS LICENSED UNDER THE AVC PATENT PORTFOLIO LICENSEFOR THE PERSONAL USE OF A CONSUMER OR OTHER USES IN WHICH ITDOES NOT RECEIVE REMUNERATION TO (i) ENCODE VIDEO IN COMPLIANCEWITH THE AVC STANDARD (“AVC VIDEO”) AND/OR (ii) DECODE AVC VIDEOTHAT WAS ENCODED BY A CONSUMER ENGAGED IN A PERSONAL ACTIVITYAND/OR WAS OBTAINED FROM A VIDEO PROVIDER LICENSED TO PROVIDE AVCVIDEO. NO LICENSE IS GRANTED OR SHALL BE IMPLIED FOR ANY OTHER USE.ADDITIONAL INFORMATION MAY BE OBTAINED FROM MPEG LA, L.L.C. SEEHTTP://WWW.MPEGLA.COM.Accordingly, please be advised that service providers, content providers,and broadcasters may be required to obtain a separate use license fromMPEG LA prior to any use of AVC/H.264 encoders and/or decoders.ROVI CORPORATION COPYRIGHTNOTICEThis product incorporates copyright protection technology that is protectedby U.S. patents and other intellectual property rights of Rovi Corporation.Use of this copyright protection technology must be authorized by RoviCorporation, and is intended for home and other limited viewing uses onlyunless otherwise authorized by Rovi Corporation. Reverse engineering anddisassembly are prohibited.DisclaimerCisco Systems, Inc. assumes no responsibility for errors or omissions thatmay appear in this guide. We reserve the right to change this guide at anytime without notice.Protect the Product from LightningIn addition to disconnecting the AC power from the wall outlet, disconnectthe signal inputs.Verify the Power Source from the On/OffPower LightWhen the on/off power light is not illuminated, the apparatus may stillbe connected to the power source. The light may go out when theapparatus is turned off, regardless of whether it is still plugged into anAC power source.Eliminate AC Power/Mains OverloadsWARNING: Avoid electric shock and fire hazard! Do notoverload AC power/mains, outlets, extension cords, or integralconvenience receptacles. For products that require batterypower or other power sources to operate them, refer to theoperating instructions for those products.Handling Disposable BatteriesThis product may contain disposable batteries. Heed the following warningand follow the Battery Safety and Battery Disposal instructions below.WARNING: There is danger of explosion if the battery ismishandled or incorrectly replaced. Replace only with the sametype of battery. Do not disassemble it or attempt to recharge itoutside the system. Do not crush, puncture, dispose of in fire,short the external contacts, or expose to water or other liquids.Dispose of the battery in accordance with local regulations andinstructions from your service provider.Battery Safety• Insert batteries correctly. There may be a risk of explosion if thebatteries are incorrectly inserted.• Do not attempt to recharge ‘disposable’ or ‘non-reusable’ batteries.• Please follow instructions provided for charging ‘rechargeable’batteries.• Replace batteries with the same or equivalent type that we recommend.• Do not expose batteries to excessive heat (such as sunlight or fire).• Do not expose batteries to temperatures above 100°C (212°F).Battery Disposal• The batteries may contain substances that could be harmful to theenvironment.• Recycle or dispose of batteries in accordance with the batterymanufacturer’s instructions and local/national disposal and recyclingregulations.• The batteries may contain perchlorate, a known hazardous substance,so special handling and disposal of this product might be necessary.For more information about perchlorate and best managementpractices for perchlorate-containing substance, see www.dtsc.ca.gov/hazardouswaste/perchlorateProvide Ventilation and Select a Location• Remove all packaging material before applying power to the product.• Do not place this apparatus on a bed, sofa, rug, or similar surface.• Do not place this apparatus on an unstable surface.• Do not install this apparatus in an enclosure, such as a bookcase or rack,unless the installation provides proper ventilation.• Do not place entertainment devices (such as VCRs or DVDs), lamps,books, vases with liquids, or other objects on top of this product.• Do not block ventilation openings.Canada EMI RegulationThis Class B digital apparatus complies with Canadian ICES-003.Cet appareil numérique de la class B est conforme à la normeNMB-003 du Canada.20081121 FCC StandardENERGY STAR® NoticeThis Cisco product has earned the ENERGY STAR.Products that earn the ENERGY STAR reduce greenhousegas emissions by meeting strict energy efficiency guidelinesset by the U.S. Environmental Protection Agency and theU.S. Department of Energy. ENERGY STAR is a registeredmark owned by the U.S. government.Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S. and other countries. A listing of Cisco’s trademarks can befound at www.cisco.com/go/trademarksENERGY STAR and the ENERGY STAR mark are registered trademarks of the U.S. government.HDMI, the HDMI logo, and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC in the United States and other countries.Rovi is a trademark of Rovi Corporation.Other third party trademarks mentioned are the property of their respective owners.The use of the word partner does not imply a partnership relationship between Ciscoand any other company. (1009R)Product and service availability are subject to change without notice.© 2011-2012 Cisco and/or its affiliates. All rights reserved.February 2012 Printed in United States of America Part Number 4040685 Rev CPOWER DTA 170HDCisco Systems, Inc. 678 277-11205030 Sugarloaf Parkway, Box 465447 800 722-2009Lawrenceville, GA 30042 www.cisco.comNote: This illustration may vary from the actual product.

/ 3

Related manuals for Cisco DTA 170HD