Cisco Catalyst 9600 Installation Manual

Also see for Catalyst 9600 Series: Installation note Hardware installation guide Manual

Installing the Switch• Unpacking the Switch, on page 1• Install the Switch as Shipped, on page 2• Install the Switch with Shelf Brackets, on page 8• Install the Switch in NEBS-Compliant Mode, on page 22• Establishing System Ground, on page 29• Attaching an ESD Strap, on page 32• Verifying the Switch Chassis Installation, on page 33Unpacking the SwitchCheck the contents of the shipping container:ProcedureStep 1 Check the contents of the accessory kit. Verify that you have received all the listed equipment, including anyoptional equipment you may have ordered, such as, network interface cables, transceivers, or special connectors.Step 2 Check the modules in each slot. Ensure that the configuration matches the packing list and that all of thespecified interfaces are included.Step 3 Store the shipping carton.Do not discard the shipping container when you unpack the switch. Flatten the shipping cartons andstore them with the pallet. You will require these containers if you have to move or ship the switchin the future.TipInstalling the Switch1