Cisco Business Edition 7000 Installation Manual

Also see for Nexus 7000 Series: Switch Guide Installation instructions Replacement instructions Manual Reference guide

Contents

Installation• Power On and Initial Setup, page 1• Customize Hypervisor for Remote Access, page 3• Access and Configure Hypervisor, page 7• Using Predeployed Virtual Machines, page 12• Deploy New Virtual Machines , page 12• Install Applications on Virtual Machines, page 13Power On and Initial SetupProcedureStep 1 Verify that the monitor and keyboard are connected as described in the Quick Start Guide.Step 2 Power on the monitor.Step 3 Verify that power is connected and the Power LED status, as shown in Figure 1: Power and LED Status -BE7000M Server, on page 1 and Figure 2: Power and LED Status - BE7000H Server, on page 2.Figure 1: Power and LED Status - BE7000M ServerIf the status of the Power LED is orange, that indicates server is off. If it is not, check the electrical and networkconnections. If the status of the Power LED is green, skip forward to step 5.Cisco Business Edition 7000 Installation Guide, Release 11.61