Canon imagePROGRAF iPF815 Basic Manual

Also see for imagePROGRAF iPF815: Technical documents Brochure Basic guide Basic guide Setup guide

Canon imagePROGRAF iPF815 Basic Manual Manual pdf 14 page image

14Remove any loaded paper that will not be used.•If the Wheeled Output Stacker is installed, remove it in advance. (→"Using the Wheeled Output Stacker," UserManual)•If the Platen is dirty, clean inside the Top Cover. (→ , If Paper is Soiled)•See the following procedure for instructions on attaching the Roll Holder to the roll.•Be careful not to pinch your fingers between the Roll Holder shaft (a) and the guide grooves (b) whenloading rolls.•Rolls: (→ , Removing the Roll from the Printer)•Sheets: (→ , Removing Sheets)•After pressing the Load/Eject button, you can refer to instructions on the Display Screen as you load the paper.(→"Checking Instructions During Printer Operations," User Manual)•(→ , Attaching the Roll Holder to Rolls)132Confirm that a roll is selected as the paper source.(→"Selecting the Paper Source," User Manual)Holding the Roll Holder so that the side with the whitegear faces the side of the Roll Holder Slot with a whitegear, load the Roll Holder shaft (a) into the grooves (b)on both ends of the Roll Holder Slot.You can load rolls in two positions, in the Roll 1 (Upper) and Roll 2 (Lower) holders. (iPF825 only)Load a roll in the printer (iPF825: in the Roll 1 (Upper) position)Open the Top Cover and lift the Ejection Guide.Loading Rolls in the PrinterLoad rolls in the printer as follows.OKab a b