Canon imagePROGRAF iPF815 Basic Manual

Also see for imagePROGRAF iPF815: Technical documents Brochure Basic guide Basic guide Setup guide

Canon imagePROGRAF iPF815 Basic Manual Manual pdf 12 page image

12Cut the edge of the roll paper if it is uneven, dirty, or has taperesidue. Otherwise, it may cause feeding problems and affect theprinting quality.•Align the edges of the paper on both ends of the roll.•For details on supported sizes and types of rolls, see "Paper Sizes" or the Paper Reference Guide.•Be careful not to cut through any barcodes printed on the roll.After pressing the Load/Eject button, you can refer to instructions on the Display Screen as you load the paper.•(→"Paper Sizes," User Manual)(→"Types of Paper," User Manual)Set the roll on a table or other flat surface so that it does not roll or fall. Rolls are heavy, and dropping a roll maycause injury.•12When printing on rolls, attach the Roll Holder to the roll.Rolls have a two- or three-inch paper core. Use the correct attachment for the paper core. The printer comesequipped with the 2-Inch Paper Core Attachment installed.Using the 2-Inch Paper Core Attachment•Using the 3-Inch Paper Core Attachment•2-Inch Paper Core Attachment (a)3-Inch Paper Core Attachment #1 (b)3-Inch Paper Core Attachment #2 (c)Lift the Holder Stopper lever (a) from the shaft side tounlock it. Holding the Holder Stopper at the positionindicated (b), remove it from the Roll Holder.When using a 3-inch paper core, align the tips (a) of3-Inch Paper Core Attachment #1 with the holes (b) ofthe Roll Holder and insert it firmly.Attaching the Roll Holder to RollsAttach the roll holder to rolls as follows.Paper toPrepare(a) (b) (c)abab