Canon imageFORMULA DR-2580C Startup Manual

Also see for imageFORMULA DR-2580C: Brochure & specs Brochure & specs Brochure & specs Brochure & specs Brochure & specs

Contents

Canon imageFORMULA DR-2580C Startup Manual Manual pdf 8 page image

6 Before Using the ScannerAbout the AC adapter• Connect only to a power outlet of the rated voltage and power supplyfrequebcy. (Either 120 V, 60 Hz or 220-240 V, 50/60 Hz depending onyour region.)• Do not connect to power outlets with other electrical devices. Also, whenconnecting via an extension cord, check the amperage rating.• Disassembling and/or reassembling the AC adapter is extremely dengerousand should not be attempted under any circumstances.• Do not place heavy objects on the AC adapter or power cord. Do not placethe adapter or cords in an area where they are likely to be stepped on.• Do not use the power cord while it is bundled.• Never pull directly on the power cord. To remove the plug from the outlet,grasp the plug directly and remove.• Keep the area around the power plug clear of articles so that the power plugcan be disconnected in an emergency.• Use only the AC adapter provided with the product. Also do not use thescanner’s AC adapter with any other product.120 V Model: MH3-2053 or MG1-3607220-240 V Model: MH3-2054 or MG1-3607• If unclear about the AC adapter, contact your local authorized dealers orservice representative for futher information.Moving the Scanner• When moving the scanner, always hold it with both hands to avoiddropping it. The scanner weighs approximately 3.9 lb (1.8 kg) alone, andapproximately 7.9 lb (3.6 kg) with the optional flatbed scanner unitinstalled.• Make sure that the flatbed scanner unit is correctly attached to theDR-2580C scanner before moving the scanner while the optional flatbedscanner unit is attached.• Make sure to disconnect the interface cable and power cord. If the scanneris transported with these items plugged in, the plugs and connectors may bedamaged due to physical shock or concussion.With optional flatbed scannerunit installed