Error CodeError Code DetailsE000-0000-- Fixing temperature control startup failureDetection Description Temperature of the Fixing Unit does not reach the specified temperature within the specified periodof time.Remedy 1. Check the harness/connector of the Fixing Unit.2. Replace the Fixing Film Unit.3. Replace the Fixing Unit.4. Replace the Engine Controller PCB.E001-0000-- Abnormal high temperature of the Fixing UnitDetection Description It was detected that the temperature of the Fixing Unit was abnormally high.Remedy 1. Check the harness/connector of the Fixing Unit.2. Replace the Fixing Film Unit.3. Replace the Fixing Unit.4. Replace the Engine Controller PCB.E003-0000-- Abnormal low temperature of the Fixing AssemblyDetection Description It was detected that the temperature of the Fixing Assembly was abnormally low.Remedy 1. Check the harness/connector of the Fixing Unit.2. Replace the Fixing Film Unit.3. Replace the Fixing Unit.4. Replace the Engine Controller PCB.E004-0000-- Fixing Heater drive circuit errorDetection Description A frequency failure was detected in the Fixing Assembly.Remedy 1. Check the harness/connector of the Fixing Unit.2. Replace the Fixing Film Unit.3. Replace the Fixing Unit.4. Replace the Engine Controller PCB.E015-0001-- Developing Disengagement errorDetection Description A developing disengagement error was detected.Remedy 1. Check the harness/connector between the Developing Disengagement Solenoid and the EngineController PCB.2. Check the harness/connector between the Main Motor and the Engine Controller PCB.3. Replace the Developing Disengagement Solenoid.4. Replace the Motor PCB.5. Replace the Engine Controller PCB.E066-0000-- Environment Sensor errorDetection Description An error in the Environment Sensor was detected.Remedy 1. Check the harness/connector between the Environment/Pickup Sensor PCB and the DCController PCB.2. Replace the Environment/Pickup Sensor PCB.3. Replace the Engine Controller PCB.E100-0001-- BD errorDetection Description BD error was detected.Remedy 1. Check the harness/connector between the Laser Scanner Unit and the Engine Controller PCB.2. Replace the Laser Scanner Unit.3. Replace the Engine Controller PCB.7. Error/Jam/Alarm238
