xxLegal NoticesLegal NoticesThe Telephone Consumer Protection Act of 1991 makes it unlawful for any person to use a computer or other electronic device,including FAX machines, to send any message unless such message clearly contains in a margin at the top or bottom of eachtransmitted page or on the first page of the transmission, the date and time it is sent and an identification of the business or other entity,or other individual sending the message and the telephone number of the sending machine or such business, other entity, or individual.(The telephone number provided may not be a 900 number or any other number for which charges exceed local or long-distancetransmission charges.)In order to program this information into your machine, you should complete the procedure for registering your name, unit’s telephonenumber, time, and date in the Starter Guide.Users in CanadaPre-Installation Requirements for Canon Facsimile EquipmentA. LocationSupply a suitable table, cabinet, or desk for the machine. See Chapter 13, “Appendix,” for specificdimensions and weight.B. Order Information1. A single telephone line (touch-tone or rotary) should be used.2. Order a CA11A modular jack, which should be installed by the telephone company. If the CA11A jackis not present, installation cannot occur.3. Order a normal business line from your telephone company’s business representative. The lineshould be a regular voice grade line or an equivalent one. Use one line per unit.DDD (Direct Distance Dial) line-or-IDDD (International Direct Distance Dial) line if you communicate overseasCanon recommends an individual line following industry standards, i.e., 2,500 (touch-tone) or 500 (rotary/pulse dial) telephones. Adedicated extension off a PBX (Private Branch eXchange) unit without “Call Waiting” can be used with your facsimile unit. Key telephonesystems are not recommended because they send nonstandard signals to individual telephones for ringing and special codes, whichmay cause a facsimile error.C. Power RequirementsThe power outlet should be a three-prong grounded receptacle (Single or Duplex). It should beindependent from copiers, heaters, air conditioners, or any electric equipment that is thermostaticallycontrolled. The rated value is 115 volts and 15 amperes. The CA11A modular jack should be relativelyclose to the power outlet to facilitate installation.
