Chapter 11-39follows:1) Place an A4 or larger sheet of plain paper in the manual feed tray.2) Press the Additional Functions key, and hold down the Right Arrow key or the Left Arrow key until the LCDindicates '6. ADJUST/CLEAN'.3) Press the OK key.4) Check to make sure that the LCD indicates '1.ROLLER CLEANING', and press the OK key. In response, themachine will start cleaning the fixing pressure roller.MEMO:It takes about 3 min before the paper is delivered to the delivery tray after the cleaning of the fixing pressure rolleris started.1.1.4.3 Other Cleaning 0006-3084If images tend to be soiled, advise the user to clean the following as needed.T-1-371.1.4.4 Storing After Unpacking the Cartridge 0007-3726The photosensitive drum is made of organic photo-conducting material (OPC), and will deteriorate if exposed tostrong light. It is also used to hold toner inside it after setting the toner bottle. Be sure to advise the user to be fullycareful when storing and handling the cartridge.(The cartridge must always be put inside a protective bag for storage.)a. Use a protective bag for storage.b. Avoid areas subject to direct sunshine (e.g., near a window). Do not leave it alone inside a card, as the temperaturecan rise to an extremely high level. (These are also true even if the cartridge is put in a protective bag.)c. Avoid areas subject to high temperature/humidity or low temperature/humidity, areas subject to rapid changes intemperature or humidity, or areas subject to condensation (e.g., near an air conditioner).d. Avoid areas exposed to corrosive gas (e.g., insecticide) or salty air.e. Avoid areas subject to dust, ammonium gas, or organic solvent gas.f. Avoid areas near a CRT display, disk drive, and floppy disk. (The magnetism from the cartridge can destroy theNo. Part Instructions1 Copyboard glass Wipe it with a cloth moistened with water (andwrung well); then, dry wipe it.2 Copyboard glass retainer Wipe it with a cloth moistened with water (andwrung well); then, dry wipe it.3 Vertical size plate Wipe it with a cloth moistened with water (andwrung well); then, dry wipe it.4 White plate Wipe it with a cloth moistened with water (andwrung well); then, dry wipe it.
